You only use the switchport command on switches-not routers. In terms of the configuration of the routed port, you can get into interface configuration mode of a switch and issue the command no switchport. This helps Layer 3 switch reach the default router during the configuration of VLAN. What is the no shut command? Why do we use no Switchport command?ДЄs mentioned above, the no switchport command is mainly used to configure routed ports. The show vlans command lists the VLANs currently running in the switch, with VID, VLAN name and VLAN status. вЂ¦ What is the command to check what VLANs are set?Дisplaying a switch VLAN configuration. The SVI provides a virtual interface for remote access to the switch. The SVI provides a faster method for switching traffic between ports on the switch.

The SVI provides a physical interface for remote access to the switch. An SVI interface can act as a parent interface for VLAN virtual interfaces.Each SVI interface can have one or several IP addresses configured.Each SVI interface can be assigned to a switch group.Now go to Steam folder -> Open вЂuserdataвЂ™.ДЄn SVI interface has the following characteristics:.Copy вЂcfgвЂ™ folder to where you want to back up the files.Open Steam Library -> Right Click on Counter-Strike: Global Offensive -> Properties.WhatвЂ™s more, the routed port isnвЂ™t joined to any VLANs and do not support VLAN subinterfaces.

This command can convert a Layer 2 port into a Layer 3 port and makes the port operate like a router interface rather than a switch port. The no switchport command is provided by the interface on a Layer 3 capable switch. Why are some FastEthernet ports on the switches are up and others are down? The FastEthernet ports are up when cables are connected to the ports unless they were manually shutdown by the administrators. Why are some FastEthernet ports on the switches up and others down? What are the three characteristic of SVI?.What is the shortest version of copy running config startup config?.What is the command to check what VLANs are set?.What are two characteristics of an SVI?.What are three characteristics of an SVI?.What is the shortest acceptable equivalent copy running config startup-config?.

Why do you enter the no shutdown command?.

How do I see active ports on a Cisco switch?.

Why does the switch respond with startup config is not present?.

Why are some FastEthernet ports on the switches up and others down?.

Startup config is not present